Recalls (4)
Seats — Mid/rear assemblyCampaign 05V480000 · 17 Oct 2005Problem: On certain mini vans equipped with a folding third row rear seat, when the third row seat is raised from its stowed position, it engages striker brackets, one on each side of the seat cushion. The fold-away striker loop is welded to a mounting bracket. The striker may become detached from its mounting bracket due to a broken weld at the point of attachment to the bracket.
Risk: If the third row seat striker weld fails, the striker could separate from the mounting bracket. Striker separation could affect the risk of injury in certain types of crashes.
Remedy: Dealers will replace the third row seat striker brackets free of charge. The recall began on december 19, 2005. Owners may contact nissan at 1-800-647-7261.
Seats — Mid/rear assemblyCampaign 05V474000 · 13 Oct 2005Problem: On certain mini vans, there is a seat adjustment mechanism that contains exposed moving components located at the rear inside edge of the second row seat.
Risk: When the operator attempts seat adjustment, a finger may be pinched in the moving seat adjustment mechanism which could cause an injury.
Remedy: On earlier model vehicles built through june 28, 2004, dealers will replace the inboard second row seat adjustment handle, rivet a plastic reinforcement to backside of the existing seat back cover carpeting, install tie-downs and a flange to the inboard side shield. On vehicles produced from june 29, 2004 through september 26, 2005, dealers will rivet a plastic reinforcement to the backside of the existing seat back cover carpeting, install tie-downs and a flange on the inboard side shield. The recall began on december 19, 2005. Owners may contact nissan at 1-800-647-7261.
Latches/locks/linkages — LatchCampaign 04V186000 · 16 Apr 2004Problem: On certain minivans equipped with a power sliding door(s), at an ambient temperature below approximately 40 degrees fahrenheit, the actuator for the power sliding door(s) may experience binding due to an out-of-specification condition. In order to open, close or reverse a power sliding door, the shift selector lever must be in "park." if the actuator is experiencing binding and the driver shifts the vehicle out of "park" while a power sliding door is still closing, the door latches may not engage.
Risk: This can result in the door coming open unexpectedly upon rapid acceleration, and an occupant could fall out of the door and be injured.
Remedy: Dealers will replace the actuator for the power sliding door(s). Owner notification began on june 23, 2004. Owners should contact nissan at 1-800-647-7261.
Air bags — Sensor/control module-inactiveCampaign 04V103000 · 01 Mar 2004Problem: Certain passenger vehicles fail to comply with the advanced air bag requirements of federal motor vehicle safety standard no. 208, "occupant crash protection." the air bag for the front passenger seat is to be turned off (so that it does not inflate) when certain occupants, such as small children, are in the front seat.
Risk: This reduces the risk of such occupants being unjured by an inflating air bag in a collision.
Remedy: Dealers will inspect the front passenger seat cushion/sensor assembly. If the seat cushion/sensor is found to be operating improperly, the seat will be removed and recalibrated. Owner notification began on june 23, 2004. Owners should contact nissan at 1-800-647-7261.