Recalls (6)
Electrical system — WiringCampaign 14V251000 · 14 May 2014Problem: General Motors LLC (GM) is recalling certain model year 2005-2007 Chevrolet Corvette vehicles manufactured March 29, 2004, through June 22, 2007. In the affected vehicles, the underhood bussed electrical center (UBEC) housing can expand and cause the headlamp low beam relay control circuit wire to bend. If the wire is repeatedly bent, it may fracture causing a loss of low beam headlamp illumination.
Risk: The loss of low beam headlamp illumination will decrease the driver's visibility, as well as the vehicle's conspicuity to other motorists, increasing the risk of a crash.
Remedy: GM will notify owners, and dealers will install a jumper wire to correct this condition, free of charge. The recall began January 2, 2015. Owners may contact Chevrolet customer service at 1-800-222-1020. GM's number for this recall is 13146. Note: Model year 2008-2013 Chevrolet Corvettes will be covered under customer satisfaction program number 14203 for the same issue.
Steering — ColumnCampaign 10V172000 · 26 Apr 2010Problem: Gm is recalling certain model year 2005 and 2006 chevrolet corvette passenger cars manufactured between march 2004 and january 2006 equipped with a tilt and telescoping steering column (rpo n37). In rare cases, repeated movement of the steering column may cause a signal interruption within the column. If this occurs, the message, "service active handling system" will appear in the driver information center, and one or more of the brakes may apply, possibly causing the vehicle to pull to the right or left.
Risk: If the driver does not respond to the change in vehicle movement, a crash could occur.
Remedy: Gm will notify owners and dealers will repair the vehicles free of charge. The safety recall began on april 30, 2010. Owners may contact chevrolet at 1-800-630-2438 and gmc at 1-866-996-9463 or at the owner center at www.gmownercenter.com.
Structure — Roof and pillarsCampaign 09V491000 · 23 Dec 2009Problem: General motors is recalling certain model year 2005 through 2007 corvette vehicles equipped with a removable roof and model year 2006 and 2007 corvette z06 vehicles. The adhesive between the roof panel and the frame may separate. If there is a partial separation, the driver may notice one or more symptoms, such as a snapping noise when driving over bumps, wind noise, poor roof panel fit, roof panel movement/bounce when a door or hatch is closed, or a water leak in the headliner.
Risk: If there is a complete separation, the roof panel may detach from the vehicle. If this were to occur while the vehicle was being driven, it could strike a following vehicle and cause injury and/or property damage.
Remedy: Dealers will install a new design roof panel free of charge. The safety recall is expected to begin during april 2010. Owners may contact chevrolet at 1-800-630-2438 or at www.gmownercenter.com.
Structure — Roof and pillarsCampaign 06V181000 · 24 May 2006Problem: On certain 2005-2006 chevrolet corvettes equipped with painted roofs, the adhesive between the roof panel and the frame may separate.
Risk: If there is a complete separation, the roof panel may detach from the vehicle and it could strike another vehicle and cause injury and property damage.
Remedy: Dealers will inspect vehicles free of charge for potential roof panel-to- frame separation and add the specified adhesive foam or replace the roof with one having adhesive foam. The recall began on october 19, 2006. Owners may contact chevrolet at 1-800-630-2438.
Steering — Hose, piping, and connectionsCampaign 05V455000 · 05 Oct 2005Problem: Certain passenger vehicles may have been built with a power steering hose that is not to specification. Under extreme steering maneuvers, such as turning the steering wheel fully to the left or right while braking, the hose may fracture and leak fluid.
Risk: If this were to occur, power steering assist would be lost and increased steering effort would be required. On vehicles equipped with hydro-boost power brakes, it could also result in loss of power brake assist and increased braking effort would be required. If the power steering fluid spray were to spray onto hot engine parts, an engine compartment fire could occur.
Remedy: Dealers will inspect the power steering hose(s) for two suspect date codes and replace them if required. The recall will begin on october 14, 2005. Owners may contact chevrolet at 1-800-630-2438, gmc at 1-866-996-9463, buick at 1-866-608-8080, cadillac at 1-866-982-2339, isuzu at 1-800-255-6727, or hummer at 1-800-732-5493.
Service brakes, hydraulic — Hoses, lines/piping, and fittingsCampaign 04V525000 · 03 Nov 2004Problem: Certain passenger vehicles were produced with one or both rear brake hydraulic lines that can come in contact with or be affected by heat from the left engine exhaust manifold and the left exhaust pipe. The brake fluid could reach elevated temperatures and boil.
Risk: If the brake fluid boils in a rear brake line, the effectiveness of the rear brake system would be reduced which could result in a brake line leak and loss of brake fluid. If enough fluid leaks from the rear brake system so that brake pedal application can no longer build pressure to the rear brakes. The operator of the vehicle will experience limited braking which could result in a crash.
Remedy: Dealers will (1) inspect the left engine exhaust manifold clip for proper alignment and placement on the body-mounted stud. If incorrect, they will reposition the clip on the brake lines and reinstall the clip on the stud; (2) the dealer will verify that both rear brake lines have the proper clearance to the left exhaust pipe. They will reposition the lines by bending as necessary; (3) dealers will remove the machining tab from the rear differential housing. Also, dealers are to inspect the brake lines for wear in these related areas and repair or replace if there is any sign of wear-through on the nylon overcoating. The recall began on january 18, 2005. Owners should contact cadillac at 1-866-982-2239 or chevrolet at 1-800-630-2438.